+86 153 6125 1873

EN
kaikki kategoriat
Pyydä mukautettu tarjous nyt!!

Blogi

Sinä olet täällä : Etusivu>Blogi

Printing company ten printing dust removal method

Aika: 2019-12-13 Osumat: 94

Printing company ten printing dust removal method

1. Tape wound on the paper feeding wheel

Tape dedusting is a double-sided tape or fiber tape wound on the paper wheel, through the adhesive tape for dusting. This method has the advantages of obvious effect of early dedusting and convenient installation.

2. Tape on the cardboard

When the printing plate is stuck by the dust, resulting in the printing white. At this time, the double-sided adhesive paste on the printing white leakage position, then proceed to print.

3. Straight brush

A printing press usually has a row of bristles. The bristles become worn and dusty because they have been used for too long. This brush is to be cleaned regularly and maintained, if the brush wear then the brush has no dust removal function.

4. Roller brush

The general is to add a printing unit, above the installation of 2 brush rollers. The speed of the brush is lower than the speed of the equipment, and the dust is collected by the speed difference of the brush rotation.

5. Vesi

Install the first color in a block of paper, then add water and dust the paper board with water.

6. Siivous Ishayoiden opettaman laitteet

It is not timely to clean the equipment, and it has accumulated a lot of dust on the top of the equipment for a long time. When the equipment is opened, it will vibrate, and the dust will fall on the cardboard or printing plate, resulting in poor printing. Equipment cleaning is very important.

7.Ground sprinkling

The main source of dust on the ground is the slotting unit. The paper ash generated during slotting is easy to fly in the equipment, so water should be sprayed on the equipment ground. The ash would fall to the ground and would not fly again.

8. Washing tube

Install a line of vacuums on the edge of the brush, , joka on similar to a vacuum cleaner, except that the suction hole runs through the width of the printer.

9. Cardboard empty run

The paperboard is dusted directly through the press unit and then painaaing book. This method is relatively time-consuming, cardboard easy to crush. Not recommended.

10. Removal method

This method is the simplest and most time-consuming, relatively good results. Is a piece of cardboard with a brush to brush, and then after finishing for tulostus kirja. The number of cardboard can be used less, more not very time-consuming.


Jos olet kiinnostunut lisää  kirjojen painatus, Tervetuloa  www.bookprintingchina.com, että the consultation email at sales@bookprintingchina