Contact Us
+(86) 755-4476810
Yangang Street No.5, Haizhu District, Guangzhou City, Guangdong Province, China
Share Us
Popular binding ways
Popular surface options
Get Free Quote
Excellent Review
Printing company ten printing dust removal method
Printing company ten printing dust removal method
1. Tape wound on the paper feeding wheel
Tape dedusting is a double-sided tape or fiber tape wound on the paper wheel, through the adhesive tape for dusting. This method has the advantages of obvious effect of early dedusting and convenient installation.
2. Tape on the cardboard
When the printing plate is stuck by the dust, resulting in the printing white. At this time, the double-sided adhesive paste on the printing white leakage position, then proceed to print.
3. Straight brush
A printing press usually has a row of bristles. The bristles become worn and dusty because they have been used for too long. This brush is to be cleaned regularly and maintained, if the brush wear then the brush has no dust removal function.
4. Roller brush
The general is to add a printing unit, above the installation of 2 brush rollers. The speed of the brush is lower than the speed of the equipment, and the dust is collected by the speed difference of the brush rotation.
5. Water
Install the first color in a block of paper, then add water and dust the paper board with water.
6. Cleaning the equipment
It is not timely to clean the equipment, and it has accumulated a lot of dust on the top of the equipment for a long time. When the equipment is opened, it will vibrate, and the dust will fall on the cardboard or printing plate, resulting in poor printing. Equipment cleaning is very important.
7.Ground sprinkling
The main source of dust on the ground is the slotting unit. The paper ash generated during slotting is easy to fly in the equipment, so water should be sprayed on the equipment ground. The ash would fall to the ground and would not fly again.
8. Washing tube
Install a line of vacuums on the edge of the brush, which is similar to a vacuum cleaner, except that the suction hole runs through the width of the printer.
9. Cardboard empty run
The paperboard is dusted directly through the press unit and then printing book. This method is relatively time-consuming, cardboard easy to crush. Not recommended.
10. Removal method
This method is the simplest and most time-consuming, relatively good results. Is a piece of cardboard with a brush to brush, and then after finishing for printing book. The number of cardboard can be used less, more not very time-consuming.
If you are interested in more about book printing, welcome to www.bookprinting.joowp.com, and the consultation email at sales@bookprintingchina.
